Further information:

The sterilizer is equipped with tongs to allow the removal of hot elements.

When the process is complete, the sterilizer will automatically turn off. An audible signal will sound to inform you that the process is complete and the indicator light will turn off.

Store the device in its box or in a clean, dry place. Never store the sterilizer when it is dirty or wet, and do not wrap the power cord around the device.

Use boiled water for disinfection to minimize scale build-up on the device. Do not use softened water in the sterilizer.

Important! Under no circumstances should you use any other means than citric acid or vinegar to remove limescale, as this may cause irreversible damage to the product. Do not use any corrosive substances or chemicals to clean the product. Do not use bleach or chemical disinfectant solutions/tablets in the sterilizer or on the products to be disinfected in it.

How to use:

Before first use, wash the inside of the sterilizer and its components and wipe dry with a cloth. Important! Do not immerse the sterilizer body in water! Carry out the first sterilization “empty” to disinfect the inside. Pour 75 ml of water onto the heating plate. Place the base basket and then the bottle stabilizer on the structural shaft so that the necks of these elements touch. When placing the items to be disinfected, make sure that the steam can circulate effectively on all surfaces and that the condensed water can easily drain into the filter container. Place the bottles on the structure upside down by threading them through the bottle stabilizer and placing them on the pins of the base basket. Then place the basket on the stem and secure it, then insert all the accessories into it. Place the structure thus assembled in the sterilizer body and replace the cover. Plug the appliance into the electrical outlet and press the on/off switch. Do not lift the cover while the device is operating. When finished, the sterilizer will automatically switch off. You will hear a 5-time beep to inform you that the process is complete; the control diode will go out. To remove the disinfected elements, wait for the sterilizer to cool down. It should cool down for at least 3 minutes. Unplug the power cord and remove the cover. The contents of the sterilizer will remain sterile for up to 6 hours after the process is complete if the cover is not removed. The removed items should be used/removed immediately after the process is complete or re-sterilized. After using the device and removing the elements, release the filter container protection, remove the filter container, pour out the water remaining after disinfection and rinse the container. Finally, wipe the inside of the body and container with a cloth to prevent the formation of limescale or deposits. Important! You can only use the sterilizer again after approximately 1 hour. since the last disinfection. Descale the sterilizer every 4 weeks to ensure its effective functioning. Descaling can be done using a solution of citric acid or vinegar.